Tender Rejection Rate: What 14% Means for a Small Carrier
Tender rejection rate hit 14.4% in September 2026. What a rejected tender is, why it lands on a small carrier's phone, and how to take it without losing money.

What is a tender rejection, and why should a small carrier care?
A tender is a shipper offering a load to a contracted carrier at the agreed contract rate. A rejection is that carrier saying no. When rejection rates run near 14%, roughly one contracted load in seven is getting re-sourced, and re-sourced freight is exactly what reaches a five-truck fleet as a broker's coverage call or a load-board post.
That is why the number matters to you even though you never receive a tender. It is not a statistic about the mega-fleets. It is a phone-will-ring index for your desk.
Where does the rejection rate sit right now?
Traffix's bi-weekly market update on September 8, 2026 put tender rejections at approximately 14.4%, after several weeks of easing, with capacity still limited. That same note had spot rates back up to around $3.38 per mile following the mid-August cooling, and truckload volumes running 4 to 5 percent below last year.
For context on how unusual 14% is, Trucking Dive reported in March 2026 that rejection rates hit nearly 14.3% in early February, and that the rate had previously hovered around 5% for parts of 2023 through 2025. Werner Enterprises CEO Derek Leathers called readings above 14% "COVID-level type rejection rates" at a February investor conference. That February spike was heavily weather-driven. Harsh Midwest winter conditions pushed the regional rate above 18% in early February, the highest since March 2022 according to the SONAR and Ryder report.
Put the two together and the plain reading is this: freight is not growing. Volumes are still down 4 to 5 percent year over year. What is happening is that loads are moving off routing guides and onto the spot desk. That is a capacity story, and in a capacity story, you are the capacity.
Why does a rejected tender land on your desk an hour later?
Walk the chain. A food shipper in Iowa tenders a reefer load, Des Moines to Memphis, to its primary carrier at the contract rate. The primary rejects it, not out of spite, but because its trucks are already committed on higher-paying lanes this week. The shipper's routing guide falls through to the next carrier, then the next, and by mid-morning it is with a broker who needs the load covered before the shipping window closes that afternoon.
That broker now has a few hours and a list. They do not run a tournament. They call the three carriers who answered fast and delivered clean last time.
Understand what the broker is buying under that time pressure. It is not the cheapest truck. It is certainty: a truck that is actually where the carrier says it is, a rate confirmation that comes back signed and booked in minutes instead of tomorrow, and a driver who shows up with paperwork the shipper will not kick back.
How do you become the carrier the broker calls back?
Answer with a real position, not a guess. When the broker asks where your truck is, "he should be getting close to Little Rock" is a different answer from "he is 40 miles out, I am looking at him." Continuous GPS on the HQ live map is why the second answer is possible, and it is a core piece of what makes an AI dispatch platform useful on a day like this instead of a dashboard nobody opens.
Turn the rate con around fast. This is where the minutes actually go. With AI rate-confirmation intake, the dispatcher uploads the broker's PDF and the customer, origin, destination, mileage, rate, and pickup and delivery windows come back pre-filled for review. Five to ten minutes of retyping becomes about twenty seconds of checking. When three carriers are being called on the same load, the one who confirms first usually gets it. That is the only AI feature we claim as live today, and it is live because it does one narrow thing well.
Show up with the load file the shipper expects. One-tap pickup with a load photo, a manifest photo, and a delivery photo, all stored on that load, is what turns a covered load into a repeat call. We have written separately about why a blurry BOL costs you money and about what the broker transparency rule means for your load file, so we will not re-teach either here.
One thing you can do Monday without buying anything. Keep a running list of every broker who covered re-sourced freight with you this quarter, with the lane and who you talked to. Call them before the next spike, not during it. Rejection rates move faster than relationships do, and the carriers who get called first in a tight week are the ones who were already a name instead of a MC number.
What are the two traps in a high-rejection market?
Trap one is diesel. A high rejection rate feels like the upper hand right up until you price the load wrong. EIA put the U.S. on-highway diesel average at $6.285 per gallon on September 14, 2026, up 31.8 cents in a single week and up $2.546 from a year earlier. The Traffix note from September 8 had diesel around $5.59. That is a 70-cent move inside one week, and it happened after a lot of rates got quoted.
Run it once. A 550-mile run at $3.38 per mile is $1,859. At 6.5 miles per gallon that is roughly 85 gallons, about $534 at $6.285. Add 120 miles of deadhead to get to the pickup and you are near 103 gallons, about $647, on the same $1,859 of revenue. The load did not change. Your fuel cost moved about $113 because of where the truck started. Price that same 670 miles at the $5.59 diesel from the September 8 note and you would have spent roughly $72 less on the identical run. If your fuel surcharge is weak or stale, a re-sourced load at a good-looking rate can still lose money. Our post on the diesel spike and small-fleet margin walks the full margin picture.
Trap two is the stranger. Re-sourced freight very often comes from a broker you have never hauled for, because the shipper's usual chain already failed. That is exactly the moment to not skip your homework. Vet the broker before you accept, not after the invoice ages out, and treat the load file as your defense if the load goes sideways. We covered both: vetting a broker as a small fleet and documentation as fraud protection.
To be explicit about what we are not: Howdy Dispatch is not a load board and not a freight broker. We do not find loads, we do not pick loads, and we do not accept them for you. The dispatcher decides. What the platform does is get the load you booked into the truck faster and get the paperwork back cleaner.
Contract tender vs rejected tender, from the small carrier's seat
| Contract tender | Rejected tender, now a spot load | |
|---|---|---|
| Who offered it | The shipper, through the routing guide | A broker covering a gap |
| What rate it carries | The negotiated contract rate | Whatever the market is doing that hour |
| How long you have to answer | Hours to days | Often minutes |
| What the buyer wants | Compliance with the agreement | Certainty, fast |
| What your load file must hold | The contract terms | Every photo, signature, and timestamp, because nobody here has history with you |
The honest comparison is not against another carrier's software. It is against how most small fleets run this today: a spreadsheet, a group text, and a rate con that gets retyped by hand. When the coverage call comes in at 10:40, the spreadsheet dispatcher is guessing at truck position and starting a five-minute typing job. That is the carrier who gets called second.
FAQ
Is a high rejection rate good for small carriers? Directionally, yes. More re-sourced freight means more calls and firmer spot rates. But it is only good if your cost side is covered. At $6.285 diesel, a busy week at the wrong rate is just a faster way to lose money.
Where can a dispatcher watch the rejection rate? The bi-weekly and weekly market notes from Traffix, DAT Freight & Analytics, and FreightWaves SONAR all publish it. Reading one of them every other week is enough to see a turn coming.
Does Howdy Dispatch find spot loads? No. It is not a load board. It takes the load you already booked and gets it into the truck and the paperwork back faster.
How long does a re-sourced load stay open? It varies more than anyone will admit, from minutes on a hot lane to most of a day on a quiet one. That is exactly why the point is not to be watching the board constantly. It is to be one of the three carriers the broker already trusts enough to call.
Does 14.4% mean the freight market has recovered? Not on its own. Volumes were still 4 to 5 percent below last year in Traffix's September 8 note. Rejections tell you about capacity tightness and who is saying no, not about how much freight exists.
If your dispatcher is retyping rate cons while the broker is calling the next carrier on the list, that is the gap worth closing first. Howdy Dispatch has a 14-day free trial, and no annual contract to start.
READ NEXT
Empty Miles Per Loaded Mile: What Deadhead Costs Now
Empty miles per loaded mile is the number most small fleets never run. With rates and costs both at record levels, here is the math and what it changes.
Spot Rates Just Passed Contract for the First Time Since 2022. Here Is How a Small Carrier Wins the Best Loads
Spot rates topped contract for the first time since 2022. Here is how a small carrier wins the best spot loads on speed and clean per-load documentation.


